top of page

Certificate

The CE mark is a mandatory conformity mark on many products placed on the single market in the European Economic Area.By affixing the CE marking, the manufacturer, its authorized representative, or person placing the product on the market or putting it into service asserts that the item meets all the essential requirements of all applicable EU directives and that the applicable conformity assessment procedures have been applied.

ce.png
ce.png
200810_FCC.png

The Federal Communications Commission (FCC) is a United States government agency, which is charged with regulating all non-Federal Government use of the radio and television broadcasting, and all interstate telecommunications (wire, satellite and cable) as well as all international communications that originate or terminate in the United States. It is an important factor in US telecommunication policy.

200810_FCC.png

 The Taiwanese National Communications Commission (NCC) requires type approval and certification qualification for controlled telecommunications radio-frequency equipment to ensure steady operation of equipment and minimized mutual disturbances.

NCC.png
NCC.png

The Taiwan Commodity Inspection Schemes (TCISchemes) are administered by the Bureau of Standards, Metrology and Inspection (BSMI), which is the authority responsible for standardisation, metrology and product inspection in Taiwan. The BSMI Safety Mark ismandatory for electrical and electronic products under the Commodity Inspection Act. Testing must be done by BSMI
or designated test laboratories.

BSMI.png
BSMI.png

The TELEC mark is a specified radio equipment such as cellular phone, wireless LAN and business purpose radio used in Japan is required to conform to the technical standards regulated by the Ministry of Internal Affairs and Communications ( MIC) of Japan.

200902_TELEC.png
200902_TELEC.png

The PSE mark is a mandatory certification mark required for many electrical appliances and materials entering the Japanese market.  Products requiring the PSE mark fall under two categories regulated by the Japanese Electrical Appliance and Material Safety Law (DENAN). 

200902_PSE.png
200902_PSE.png
200810_RoHS.png

The Restriction of Hazardous Substances Directive (RoHS) was adopted in February 2003 by the European Union. The RoHS directive took effect on 1 July 2006, and is required to be enforced and become law in each member state. This directive restricts the use of six hazardous materials in the manufacture of various types of electronic and electrical equipment.

200810_RoHS.png
200810_weee.png

The Waste Electrical and Electronic Equipment Directive (WEEE Directive) is the European Community directive 2002/96/EC on waste electrical and electronic equipment (WEEE) which, together with the RoHS Directive 2002/95/EC, became European Law in February 2003. The WEEE Directive set collection, recycling and recovery targets for all types of electrical goods, with a minimum rate of 4 kilograms per head of population per annum recovered for recycling by 2009. The RoHS Directive set restrictions upon European manufacturers as to the material content of new electronic equipment placed on the market.

200810_weee.png
bottom of page